"T-LOCK" SECURITY HANGER SET INSTRUCTIONS
FOR WOODEN PICTURE FRAMES

ArtRight.com

PROCEDURE

• Position 2 plates so they are evenly spaced on the top of the frame, able to support frame.  Position plates at least 1/2" from edges so as not to be seen.  Use 1/2" screws to attach plates.  Fasten third plate in the center of the bottom of the frame.

• Position frame on the wall and mark where brackets should be located, based on position of plates on top of frame.  By pressing the plates into the wall, the plate ridges will leave marks on most types of wall surfaces.

• Attach brackets to wall using 2 short anchors and 1" screws.  Place frame on brackets, insuring proper support.  Brackets will slide into the space between frame and top plate.

• Now, press bottom plate into wall, to mark it's location.  Remove frame from wall.  Using long plastic anchor, insert T-screw until it extends 1/2" out of the wall.  Re-hang frame on brackets, tilting the bottom of the frame away from wall in order to see T-screw.  Align "T" head so that it fits into corresponding slot in bottom plate.  

• While the frame should be nearly flush to wall, a little space between frame and wall is normal.

• From below the picture frame, turn "T" screw 90 degrees using special "T-Lock" wrench.  Frame is now secure.

~ BACK TO HARDWARE SETS ~