"T-LOCK" SECURITY HANGER SET INSTRUCTIONS
FOR ALUMINUM PICTURE FRAMES

ArtRight.com

PROCEDURE

• Locate frame on wall.  Position brackets for even spacing along top frame extrusion, to support the frame.

• Attach brackets to wall using 2 short anchors and 1" screws.  Place frame on brackets, insuring proper support.  Brackets will slide directly into the frame extrusion's channel; no "plate" is required for metal frames.

• Place frame on brackets, insuring proper support.

• Now, find the exact center of the bottom of the frame (width and length), and mark this spot on the wall.  Remove frame from wall.  Using long plastic anchor, insert T-screw until it extends 1/2" out of the wall.  Re-hang frame on brackets, tilting the bottom of the frame away from wall in order to see T-screw.  Align "T" head so that it fits directly into the center of the bottom frame extrusion.  

• While the frame should be nearly flush to wall, a little space between frame and wall is normal.

• From below the picture frame, turn "T" screw 90 degrees using special "T-Lock" wrench.  Frame is now secure.

~ BACK TO HARDWARE SETS ~